你能把平地地基上的楼板抬高吗?

you would of course need a slab to be designed by an engineer, but you likely would be able to build up. Assuming soil conditions allow for it, you would simply need to add the desired amount of compactable fill to bring it up to the level you’d like. We did exactly that with ourLEED V4 Platinum Edelweiss House. This page has a video abouthow to build passive solar homes, where you can see how we raised the level of the slab with clean compactible fill, exactly as you would need to do.

You could go with a footing and frost wall, but those can sometimes be trickier to insulate properly. We recently built a new demonstration house (which is nearing completion) where we used araft slab from Legalett. We chose that partly for performance, but also because the house is seated on expansive soils, so a frost wall and footing would have required significant soil remediation. A raft slab distributes the weight evenly over the entire surface of the floor so we were able to build on the existing clay.

If you are looking to get near Passive House performance with you home then you may want to look into such a kit, below is an image of a Passive House slab under construction with 14 inches of seamless insulation on the exterior and 12 inches below the slab. Note where the doorway is in the front of the image - that is a wood fiber / cement product calledThermasillthat allows for a solid surface outside of doors while avoiding thethermal bridging of concrete.

And if you have not yet chosen a wall assembly, here is a story about that same house, which is a ‘nearly Passive House’ in Perth, Ontario. They usedLarsen trusses with Dense-packed cellulose as the wall assembly.

• Like
• Reply