...installa HRV or ERV at the same time? We are not heavy users of AC, usually setting it to 26C, mostly to take the edge off the very humid environment. Also...
Posted by David HintonMarch 4, 2022, 10:08 a.m.HRV and ERV2 Responses
...installa natural swimming pool in a backyard but don't know where to start - can you help? We are not natural swimming poolinstallers , but check out this pag...
...install1" strapping directly to the concrete first, serving as a nailing surface for securing the 5" foam with long nails/screws. This would also provide a cha...
...installmy perimeter weeping tile? I obviously cannot have it that far below my basement slab or I won’t be able to access the sump pump/pit. Thoughts? Should I...
...installtion (eg. if glued or floated)? 2) Engineered flooringinstalltion -- With the radon issue in mind, which is the best apprach toinstalling engineered ...
All, I have what I think is an unusual problem and I’d like suggestions for the best way to address it. I have a below-grade “cinder block” basement wall tha...
...installspray foam, yes you can. It just isn’t our favorite solution and we always explore all other options first. We aren’t big fans of spraying chemicals ins...
...installearth tubes or some such system that will allow my home to be more passive. My new modular will be in Pierce, Colorado. I've seen information on earth t...
Good morning, I'm looking toinstallradon mitigation (sub-slab suction). I understand it's not too difficult, but there are a few details I'm not sure about...
...Installtwo inches of rigid insulation board directly against concrete. A mold expert told me to put the board on top of the framing, not directly onto the conc...
...installa ground loop as you mention, and I’ll start with a basic explanation of that as well along with its drawbacks - A classic ground loop pulls air throu...
Posted by Lee WattJuly 10, 2018, 12:43 a.m.HRV and ERV2 Responses
Hi, I have a 1955 red all brick bungalow. the interior walls are a very thick plaster board (maybe 1" or more thick). I want to take the walls down to the stud...