...foam- specifically mineral wool insulation - read more here: The difference between Polyiso, EPS & XPSFoamInsulation & StyrofoamCheck out the follow...
...foamboard and still be a problem? Hoping to just be able to applyfoamto regulate the concrete temps and prevent inside warmer air from touching the concrete ...
...foamboard insulation attached to the stud and seams taped. Then I would set 1/2" drywall on top of thefoamand attached with long screws. Does this sound like...
...foamboard to my basement foundation walls. From all of my reading it says that your basement foundation walls can only dry to the inside. If I putfoamboard on ...
...foamboard in between my studs and tac nail it? You could putfoambetween the studs, but why not batts? Were you choosingfoamdue to reading here about using ...
We have a cabin in the Bershires of Massachusetts ceilings and floor have been insulated, dense pack celluose in ceilings 4 in Amivic graphite EPS under floors....
...boardsfor installation in my basement rim joists, should I be looking for faced or unfacedfoamboardsto install there--and which surface of theboards(faced...
...foamboard to the inside of the wall or leave a gap for air? I understand mold will not grow on the board but I am afraid that there are very small cracks in th...
...foamboard on top of the slab? Or is the 2"foamboard under the slab + the 2"foamboard vertically around sides/edges of slab and subfloor enough to counter ...
Posted by Insinuendo InsinuendoAug. 5, 2022Slab on Grade3 responses
...foamboardsI've been looking at are, Kingspan Insulation R-10 2in*4ft*8ft unfaced polystyrenefoamboard from Lowes and theFoamular 150 2in*4ft*8ft R-10 unfac...
...foamboard insulation held in place with the special plastic pegs (since the poly will not allow adhesive to affix it to the wall), blue sheathing tape onfoam...
Do you have any advice with spray cork renders vs. fully insulating the outside of our home with rockwool orfoamboard and new siding. We need a cost effective...
...foambut you can use it anywhere you would use EPS rigidfoaminsulation. EPS is typically rated at abou R4 per inch where GPS is typically rated as having R5 i...
...foamrather than a failure. The wood studs will transfer far more heat than the Spray PolyurethaneFoam(SPUF), so what you are seeing could actually be an indi...
...foamas well to prevent moisture infiltration. Also notice on that page that we raise the bottom plates of the framed wall by placing it on small blocks offoam...
...foampanels, we would recommend EPS rigidfoaminstead of XPS as it is cheaper and less environmentally harmful, read more here about the performance and charac...
